Step-by-step guide on how to use dog shampoo effectively:

Here's a step-by-step guide on how to use dog shampoo effectively:

  1. Prepare: Before starting, gather all necessary supplies, including dog shampoo, towels, and a brush. Make sure the water temperature is lukewarm, as water that is too hot or too cold can be uncomfortable for your dog.

  2. Brush: Begin by gently brushing your dog's coat to remove any tangles, mats, or loose hair. This step helps to loosen dirt and debris and ensures better penetration of the shampoo.

  3. Wet Your Dog: Thoroughly wet your dog's coat with lukewarm water. Use a handheld sprayer or a cup to wet your dog's body, ensuring that water reaches all areas, including the belly, legs, and tail.

  4. Apply Shampoo: Dispense a small amount of dog shampoo into your hand and lather it between your palms. Starting from the neck and working your way down to the tail, gently massage the shampoo into your dog's coat, paying special attention to areas that are particularly dirty or oily. Be careful to avoid getting shampoo in your dog's eyes, ears, or mouth.

  5. Massage and Soak: Take your time to massage the shampoo into your dog's coat, using gentle circular motions. Allow the shampoo to soak in for a few minutes to effectively lift dirt and oils from the skin and coat.

  6. Rinse Thoroughly: Once the shampoo has been massaged in, thoroughly rinse your dog's coat with lukewarm water. Make sure to rinse until the water runs clear and there are no traces of shampoo left behind, as leftover residue can cause skin irritation.

  7. Repeat if Necessary: Depending on the level of dirtiness, you may need to repeat the shampooing process for a more thorough clean. However, be cautious not to over-shampoo your dog, as this can strip the natural oils from their skin and lead to dryness and irritation.

  8. Dry: After rinsing, gently squeeze excess water from your dog's coat using a towel. If your dog tolerates it, you can use a hairdryer on a low heat setting to speed up the drying process. Otherwise, allow your dog to air dry naturally in a warm, draft-free environment.

  9. Brush Again: Once your dog is completely dry, give their coat another gentle brush to remove any remaining tangles and fluff up their fur.

By following these steps, you can ensure a thorough and enjoyable bathing experience for your dog, leaving them clean, fresh, and happy.


In order for your dog to be happy and you to be calm about its health and appearance, trust our natural products and feel the result immediately. Thank you!
Tel.: +44 7821 130 743
Follow us at:

© Copyright 2024 PurePup. | Terms & Conditions | Privacy Policy